Set Port Lldp - Avaya G250 Reference

CLI Commands

set port lldp

Use the set port lldp command to change the administrative lldp port status.
Syntax:
set port lldp module/port disable|rx-only|tx-only|rx-and-tx
Parameters
Parameter
module
port
disable
tx-only
rx-only
rx-and-tx
User level
read-write
Context
General
Example
G250-001(super)# set port lldp 10/3 rx-and-tx
Related commands
set lldp re-init-delay,
tx-interval, set port lldp
vlan-name config
446 Avaya G250 and Avaya G350 CLI Reference
Description
Number of module
Number of port(s)
LLDP agent will not transmit nor receive LLDP
frames on this port.
LLDP agent will transmit LLDP frames on this
port but it will not store any information about the
remote systems connected.
LLDP agent will receive, but it will not transmit
LLDP frames on this port
LLDP agent will transmit and receive LLDP
frames on this port (default)
set lldp system-control,
tlv, show lldp, show lldp
set lldp tx-delay, set lldp
config, show port lldp
Possible Default
Values Value
1-10
X
tx-hold-multiplier, set lldp
config, show port lldp