Set Port Redundancy-Intervals - Avaya G250 Reference

Note:
If you wish to define a name which includes spaces, you must enclose the entire
Note:
name in quotation marks, for example "new york".
Related commands
set port redundancy,

set port redundancy-intervals

Use the set port redundancy-intervals command to configure the two time constants
that determine redundancy switchover parameters.
Note:
This command is not supported by the G250.
Note:
Syntax
set port redundancy-intervals min_time_between_switchovers
{switchback_interval | none}
Parameters
Parameter
min_time_
between_
switchovers
switchback_
interval
none
User level
read-write
set port redundancy-intervals,
Description
The minimum time, in milliseconds,
between redundancy switchovers for
each pair
The period, in milliseconds, the
primary port link has to be "up" before
the system switches back
Specify 0 to indicate the system never
switches back
Specify 1 to indicate that switchback
occurs immediately after the primary
port link returns
Do not switch
Alphabetical listing of CLI commands
show port redundancy
Possible
Values
0-65000
0-65000
Issue 1.1 June 2005
Default
Value
459