Ip Ospf Network Point-To-Multipoint; Ip Ospf Priority - Avaya G250 Reference

ip ospf network point-to-multipoint

Use the ip ospf network point-to-multipoint command to specify the network type
as point-to-multipoint for the interface, and to increase the OSPF timers appropriately. Use the
no form of the command to return the interface to point-to-point topology.
Syntax
[no] ip ospf network point-to-multipoint
User level
read-write
Context
Interface: Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3), VLAN (L2-L3, L3), Loopback (L2-L3,
L3), Tunnel (L3, L2-L3)
Example
To specify a network type of point-to-multipoint for the VLAN 1 interface:
G350-001(if:Vlan 1)# ip ospf network point-to-multipoint
Related commands
ip ospf authentication,
hello-interval, ip ospf
ospf, show ip ospf

ip ospf priority

Use the ip ospf priority command to configure interface priority, which is used during the
election of a designated router. Use the no form of this command to set the OSPF priority to its
default value.
Syntax
ip ospf priority priority
no ip ospf priority
ip ospf authentication-key,
message-digest-key,
database, show ip ospf
Alphabetical listing of CLI commands
ip ospf cost, ip ospf
ip ospf priority, ip ospf
interface, show ip ospf
dead-interval, ip ospf
router-id, router ospf,
neighbor, show ip protocols
Issue 1.1 June 2005
show ip
263