Set Lldp Tx-Delay - Avaya G250 Reference

CLI Commands

set lldp tx-delay

Use the set lldp tx-delay command to set the TxDelay. The TxDelay sets the minimal
delay in seconds between successive LLDP frame transmissions, on each port.
The tx delay should be in the range 1 <= TxDelay <= (0.25 * TxInterval)
This transmission rate limiting applies only to situations caused by asynchronous transmission
or shutdown when the LLDP application is stopped on a port or system in an Avaya device.
Syntax
set lldp tx-delay value
Parameters
Parameter
value
User level
read-write
Context
General
Example
G250-001(super)# set lldp tx-delay 5
Related commands
set lldp re-init-delay,
port lldp, set port lldp
vlan-name config
414 Avaya G250 and Avaya G350 CLI Reference
Description
Minimum delay in seconds between successive
LLDP frame transmissions
set lldp system-control,
tlv, show lldp, show lldp
set lldp tx-hold-multiplier,
config, show port lldp
Possible Default
Values Value
1-8,192 30
set lldp tx-interval, set
config, show port lldp