Show Voip-Parameters - Avaya G250 Reference

CLI Commands

show voip-parameters

Use the show voip-parameters command to display information about the current VoIP
engine.
Syntax
show voip-parameters
User level
read-only
Context
general
Example
To display VoIP information:
G350-001(super)# show voip-parameters
VOIP ENGINE PARAMETERS
---------------------------------------------------------
IP (PMI)
DSP Firmware Version: 200
Fault Status
Additional Status
CURRENT STATE
---------------------------------------------------------
In Use
DSPs State : Idle
Admin State: Release
Related commands - VoIP testing
busyout voip-dsp,
Related commands - QoS
interface FastEthernet,
signal, show ip
732 Avaya G250 and Avaya G350 CLI Reference
: 172.16.1.139
: No Fault Messages
: No Status Messages
: 0 channels, 0 of 32 resources
release voip-dsp, test voip-dsp
interface serial, queue-limit,
qos-list, show queue,
set qos
voip-queue-delay
bearer, set qos control, set qos