Load-Interval - Avaya G250 Reference

CLI Commands
Example
To set the line-code type to ami:
G350-001(controller:5/1)# linecode ami
Related commands
cablelength long,
interface serial,

load-interval

Use the load-interval command to set the load calculation interval for an interface. Use the
no form of the command to restore the load calculation to its default value.
Note:
The load interval must be in increments of 30 seconds.
Note:
Syntax
load-interval seconds
no load-interval
Parameters
Parameter
seconds
User level
read-write
Context
Interface: Serial (DS1 PPP L2-L3, DS1 PPP L2, DS1 FR L2, USP PPP L2-L3, USP PPP L2,
USP FR L2), FastEthernet (L2, L2-L3), VLAN (L2-L3, L2), Loopback (L2-L3, L2), Tunnel (L2,
L2-L3)
Example
To set the load calculation interval to 60 seconds:
G350-001(if:Serial 2/1:1)# load-interval 60
322 Avaya G250 and Avaya G350 CLI Reference
cablelength short, channel-group,
ip address, linecode (E1), remote,
Description
The load calculation interval, in seconds.
This parameter must be divisible by 30.
clock source, controller, ds-mode, framing,
show controllers
Possible
Values
30-600
Default
Value
300