Show Port Trap - Avaya G450 Cli Reference Manual

Related Commands - SNMP access configuration
ip snmp, set snmp
engineID, show snmp
snmp usertogroup,
snmp-server group,
Related Commands - SNMP trap configuration
set port trap, set snmp trap enable | disable
link-status, snmp-server enable

show port trap

Use the show port trap command to display information on SNMP generic link up/down
traps sent for a specific port. If no port is specified, information for all ports is displayed.
Syntax
show port trap [module[/port]]
Parameters
Parameter
module
port
User Level
read-only
Context
general
Example
To display trap information for port 6/5:
G450-001(super)# show port trap 6/5
Port 6/5 up/down trap is disabled
community, set snmp
group, show snmp
show snmp view, snmp-server
snmp-server remote-user,
notifications,
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 10/5-6 for
both ETH LAN ports 5-6 on the front panel.
retries, set snmp timeout,
retries, show snmp timeout,
community,
snmp-server user,
auth, show port trap,
snmp-server host,
SNMP trap configuration
show snmp, show snmp
show snmp user,
snmp-server engineID,
snmp-server view
show snmp, snmp trap
snmp-server informs
Possible Default
Values Value
Issue 1 January 2008
show
1089