Ip Bootp-Dhcp Network - Avaya G250 Reference

Parameters
Parameter
up
down
User level
read-write
Context
Interface: Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3), VLAN (L2-L3, L3), Loopback (L2-L3,
L3), Tunnel (L2-L3, L3)
Example
G350-???(super-if:FastEthernet 10/2)# ip admin-state up
Related commands
description (interface),
serial, interface
load-interval, show ip interface brief

ip bootp-dhcp network

Use the ip bootp-dhcp network command to select the network from which the BOOTP/
DHCP server should allocate an address. This command is required only when there are
multiple IP interfaces over the VLAN. Use the no form of this command to remove the specified
network.
Note:
More than one network can be configured. For requests to servers, all configured
Note:
networks are used. The networks are used on a round-robin basis.
Syntax
ip bootp-dhcp network ip_net
no ip bootp-dhcp network [ip_net]
Description
Keyword specifying the administrative state
of the IP interface is set to up (active)
Keyword specifying the administrative state
of the IP interface is set to down (inactive)
interface Console,
tunnel, interface usb,
interface FastEthernet,
interface vlan, ip address,
Alphabetical listing of CLI commands
Possible Default
Values Value
interface Loopback,
ip broadcast-address,
Issue 1.1 June 2005
interface
225