Set Port Speed - Avaya G250 Reference

CLI Commands
Related commands
set port spantree,
spantree default-path-cost,
spantree hello-time,
spantree version,

set port speed

Use the set port speed command to configure the speed of a port or range of ports.
In auto-negotiation mode, the port's speed is determined by auto negotiation. An error message
is generated if you try to set the speed when auto negotiation is enabled
Syntax
set port speed module/port 10MB|100MB|1GB
Parameters
Parameter
module
port
10MB
100MB
1GB
User level
read-write
Context
general
464 Avaya G250 and Avaya G350 CLI Reference
set port spantree cost,
set spantree
set spantree max-age,
show spantree
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 4/5-13 for
ports 5 to 13 on module 4.
Keyword that sets the specified port to a
speed of 10 Mbps
Keyword that sets the specified port to a
speed of 100 Mbps
Keyword that sets the specified port to a
speed of 1 Gbps
set port spantree force-protocol-migration,
enable/disable, set spantree
set spantree priority,
set
forward-delay, set
set spantree tx-hold-count,
Possible Default
Values Value
set