Queue-Limit - Avaya G250 Reference

queue-limit

Use the queue-limit command to set the packet size of the various queues. Use the no form
of the command to restore the packet size to its default value, using the interface bandwidth.
Note:
The queue-limit command is not applicable in fair-voip-queue mode.
Note:
Syntax
queue-limit queue_id size
no queue-limit
Parameters
Parameter
queue_id
size
User level
read-write
Context
Interface: Serial (DS1 PPP L2-L3, DS1 PPP L2, DS1 FR L2, USP PPP L2-L3, USP PPP L2),
FastEthernet(L2-L3, L2)
Example
To specify a size of 200 for queue 1:
G350-001(if:Serial 2/1:1)# queue-limit 1 200
Related commands
interface FastEthernet,
qos-list, show queue,
Description
The queue priority ID
The size of the queue, in packets
interface serial, set qos
show voip-parameters,
Alphabetical listing of CLI commands
Possible Values
1 (highest)-4
(lowest)
The total number
of packets in all
queues cannot
exceed 5000.
bearer, set qos control,
voip-queue-delay
Default
Value
set qos signal, show ip
Issue 1.1 June 2005 361