Set Port Negotiation - Avaya G250 Reference

Example
To name port 21 of module 4 to "arthur"
G350-147# set port name 4/21 arthur
Port 4/21 name set.
Note:
If you wish to define a name which includes spaces, you must enclose the entire
Note:
name in quotation marks, for example "new york".
Related commands
set port auto-negotiation-flowcontrol-advertisement,
edge admin state,
port point-to-point admin
auto-negotiation-flowcontrol-advertisement,

set port negotiation

Use the set port negotiation command to enable or disable auto-negotiation on the
specified port. Auto-negotiation uses a link negotiation protocol to determine the highest
connection parameters available to connected ports and configures the port speed and duplex
setting of both ports. This command applies to Fast Ethernet or Gigabit Ethernet ports.
If negotiation is disabled, the user can set the speed and duplex of the Fast Ethernet ports.
Syntax
set port negotiation module/port {enable|disable}
Parameters
Parameter
module
port
enable
disable
set port enable, set port
status, set port
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 4/5-13 for
ports 5 to 13 on module 4 on the G350, or 10/
5-8 for ETH LAN ports 5 to 8 on the front panel
of the G250.
Enable port negotiation protocol
Disable port negotiation protocol
Alphabetical listing of CLI commands
set port disable,
flowcontrol, set port
speed, show port
show port edge state,
set port duplex,
level, set port negotiation,
show port flowcontrol
Possible Default
Values Value
Issue 1.1 June 2005
set port
set
451