Cabling An Ethernet Port On The Juniper Services Router - Avaya IG550 Installing And Configuring

Installing an IG550 Integrated Gateway using the Disk on Key
Figure 14: Sample illustration of Juniper Service Router and TGM550, front view (J2320
shown)
Juniper
NETWORKS
RESET
CONFIG
POWER
1 3
2
Figure notes:
1. Juniper Router Alarm LEDs
2. Juniper Router Power LEDs
3. Power button
4. Reset button
5. Console port
6. Aux port
The system starts and reads the configuration file from the Disk on Key. When the system is
running normally, the Power on LED lights steady green. The configuration file has been
downloaded, loaded, and committed. The root password is also set as part of the
configuration.
2. Remove the Disk on Key.

Cabling an Ethernet port on the Juniper Services Router

1. Plug an RJ-45 Ethernet cable into one of the Gigabit Ethernet ports on the router
(Figure 12,
2. Attach the other end of the cable to the LAN.
32 Installing and Configuring the IG550 Integrated Gateway
Analog
R J2320
ALM
ACT
1 2
TIM514
TX/RX 0/0 LINK TX/RX 0/1 LINK TX/RX
CONSOLE AUX
10/100/1000
5 6
7
4
Figure 13, Figure 14).
9
Line 3 4 5 6 Line 7 8
SLOT NUMBER
1 2
3
USB0 USB1
0/2 LINK TX/RX 0/3 LINK
8
7. Gigabit Ethernet ports
8. USB ports
9. TIM514 analog telephony interface module
10. TGM550 Telephony Gateway Module
11. Dual port T1 Physical Interface Module
10
Gateway
ASB
ALM RST
ACT
ETR
1 Trunk 2
Console
TGM550
1xGE SFP
PORT 0 PORT 1
STATUS
11
hwma232c LAO 041907
3 Line 4
STATUS