Show Port Auto-Negotiation-Flowcontrol-Advertisement - Avaya G250 Reference

CLI Commands
Example
To display the status for port 4 on module 3:
G350-001(super)# show port 3/4
Port Name
---- ------- ------- ---- ----- ------- ---- ---- -------------
3/4 NO NAME no link
Output fields
Name Description
Port Module and port number
Name Name of port
Status Status of the port — connected, faulty, disabled, no link
Vlan VLAN ID of the port
Level Priority level of the port — 0-7
Neg Autonegotiation status of the port — enabled, disabled
Dup Duplex setting for the port — full, half
Speed Speed setting for the port — 10, 100, 1000
Type Port type, for example:
10/100BASE-TX, GBIC_SX, GBIC_LX, GBIC_not present, GBIC_unknown
Related commands
show port point-to-point status

show port auto-negotiation-flowcontrol-advertisement

Use the show port auto-negotiation-flowcontrol-advertisement command to
display the flowcontrol advertisement for a Gigabit port used to perform auto-negotiation. If no
port is specified, information for all ports is displayed.
Syntax
set auto-negotiation-flowcontrol-advertisement [module/port]
658 Avaya G250 and Avaya G350 CLI Reference
Status Vlan Level
1 0
Neg Dup. Spd. Type
enable half 10M 10/100BaseTx Port