Show Last-Pim-Update - Avaya G250 Reference

CLI Commands
Success Retries:
Failure Retries:
Success Retries Counter:
Failure Retries Counter:0
Related commands
keepalive-icmp,
source-address,

show last-pim-update

Use the show last-pim-update command to display when the last Provisioning and Update
Manager (PIM) update of the SLS data occurred on the G250.
Note:
This command is supported by the Avaya G250-Analog; it is not supported on the
Note:
G250-BRI or the G350.
Syntax
show last-pim-update
User level
read-write
Context
You must be in the survivable-call-engine context before the show last-pim-update
command will work.
Example
G250-001(super-survivable-call-engine)# show last-pim-update
Last PIM update occured at 15:47:0 on 2/28/2005
Related commands
add trunk-group,
trunk-group, remove
extension, set
survivable-call-engine,
show extension,
show trunk-group,
638 Avaya G250 and Avaya G350 CLI Reference
1
4
4
keepalive-icmp failure-retries,
keepalive-icmp success-retries,
clear ars-fac, clear
trunk-group, save
extension-password, set
set trunk-group,
show ip-codec-set,
survivable-call-engine
keepalive-icmp
keepalive-icmp timeout
survivable-config, clear
config, set ars-fac,
ip-codec-set, set max-ip-registrations,
show ars-fac, show
show max-ip-registrations,
interval, keepalive-icmp
dial-pattern, clear extension,
set date-format, set dial-pattern,
set
date-format, show dial-pattern,
show survivable-call-engine,
clear
set