Ip Telnet - Avaya G250 Reference

CLI Commands
Syntax
[no] ip tcp header-compression
User level
read-write
Context
Interface: Serial (DS1 PPP L2-L3, DS1 PPP L2, USP PPP L2, USP PPP L2-L3)
Example
To enable TCP header compression on a Serial interface:
G350-001(if:Serial 2/1:1.1) ip tcp header-compression
Related commands
clear ip tcp header-compression,
compression-connections,

ip telnet

Use the ip telnet command to enable the Telnet server. Use the no form of the command to
disable the Telnet server.
Note:
For security reasons, this command can only be executed from the Console port.
Note:
Note:
The ip telnet command is a secured command and will not be displayed
Note:
together with the running configuration (using the show running-config
command). To see the status of this command, use the show protocol
command (refer to
Syntax
ip telnet [port port_number]
no ip telnet
290 Avaya G250 and Avaya G350 CLI Reference
ip rtp header-compression,
show ip tcp header-compression
show protocol on page 676).
ip rtp non-tcp-mode, ip tcp