Set Logging Server Condition - Avaya G250 Reference

CLI Commands

set logging server condition

Use the set logging server condition command to specify a filter for messages sent
to the specified Syslog server. Messages can be filtered by source system, severity, or both.
Syntax
set logging server condition {all | Msgfacility} {none | severity}
ip_address
Parameters
Parameter
all
MsgFacility
none
severity
ip_address
User level
read-write
420 Avaya G250 and Avaya G350 CLI Reference
Description
Apply this filter to all
message facility systems
Apply this filter to messages
produced by a specific
system
Do not log any messages
Only log messages whose
severity level is equal to or
more severe than the
specified level (0 is the
highest severity, 7 the
lowest)
The IP address of the Syslog
server
Possible Values
boot, dialer, policy,
snmp, usb-modem,
cascade, dnsc, ppp, stp,
vlan, cdr, fan, pppoe,
supply, voice, cli, filesys,
qos, switchfabric, wan,
cna_tp, ipsec, router,
system, config, isakmp,
rtp-stat, tftp, console,
lag, saa, threshold,
dhcps, poe, security,
tracker
Use the text value or its
numeric equivalent:
emergency (0),
alert (1),
critical (2),
error (3),
warning (4),
notification (5),
informational (6),
debugging (7)
Default
Value