Set Port Edge Admin State - Avaya G250 Reference

set port edge admin state

Use the set port edge admin state command to specify whether or not a port is
considered to be an edge port.
Note:
This command is not supported by the G250.
Note:
Syntax
set port edge admin state module/port admin_state
Parameters
Parameter
module
port
admin_state
User level
read-write
Context
general
Example
To specify that port 3 of module 10 is an edge port:
G350-001(super)# set port edge admin state 10/3 edge-port
Related commands
set port auto-negotiation-flowcontrol-advertisement,
enable, set port
point-to-point admin
auto-negotiation-flowcontrol-advertisement,
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 4/5-13 for
ports 5 to 13 on module 4.
The type of the specified port
flowcontrol, set port level,
status, set port speed,
Alphabetical listing of CLI commands
set port disable,
set port name, set port
show port
show port edge state,
Possible Default
Values Value
edge-port,
non-edge-port
set port duplex, set port
negotiation, set port
show port flowcontrol
Issue 1.1 June 2005 441