STMicroelectronics STM32F05 series Reference Manual page 616

Universal synchronous asynchronous receiver transmitter (USART)
Bits 13:12 STOP[1:0]: STOP bits
These bits are used for programming the stop bits.
00: 1 stop bit
01: Reserved.
10: 2 stop bits
11: 1.5 stop bit
This bit field can only be written when the USART is disabled (UE=0).
Bit 11 CLKEN: Clock enable
This bit allows the user to enable the SCLK pin.
0: SCLK pin disabled
1: SCLK pin enabled
This bit can only be written when the USART is disabled (UE=0).
Note: If neither synchronous mode nor Smartcard mode is supported, this bit is reserved and forced
by hardware to '0'. Please refer to
Bit 10 CPOL: Clock polarity
This bit allows the user to select the polarity of the clock output on the SCLK pin in synchronous
mode. It works in conjunction with the CPHA bit to produce the desired clock/data relationship
0: Steady low value on SCLK pin outside transmission window
1: Steady high value on SCLK pin outside transmission window
This bit can only be written when the USART is disabled (UE=0).
Note: If synchronous mode is not supported, this bit is reserved and forced by hardware to '0'.
Please refer to
Bit 9 CPHA: Clock phase
This bit is used to select the phase of the clock output on the SCLK pin in synchronous mode. It
works in conjunction with the CPOL bit to produce the desired clock/data relationship (see
Figure 240
0: The first clock transition is the first data capture edge
1: The second clock transition is the first data capture edge
This bit can only be written when the USART is disabled (UE=0).
Note: If synchronous mode is not supported, this bit is reserved and forced by hardware to '0'.
Please refer to
Bit 8 LBCL: Last bit clock pulse
This bit is used to select whether the clock pulse associated with the last data bit transmitted (MSB)
has to be output on the SCLK pin in synchronous mode.
0: The clock pulse of the last data bit is not output to the SCLK pin
1: The clock pulse of the last data bit is output to the SCLK pin
Caution:
This bit can only be written when the USART is disabled (UE=0).
Note: If synchronous mode is not supported, this bit is reserved and forced by hardware to '0'.
Please refer to
Bit 7 Reserved, must be kept at reset value.
Bit 6 LBDIE: LIN break detection interrupt enable
Break interrupt mask (break detection using break delimiter).
0: Interrupt is inhibited
1: An interrupt is generated whenever LBDF=1 in the USART_ISR register
Note: If LIN mode is not supported, this bit is reserved and forced by hardware to '0'. Please refer to
Section 25.4: USART implementation on page
616/742
Section 25.4: USART implementation on page
and Figure 241)
Section 25.4: USART implementation on page
The last bit is the 8th or 9th data bit transmitted depending on the 8 or 9 bit
format selected by the M bit in the USART_CR1 register.
Section 25.4: USART implementation on page
Doc ID 018940 Rev 1
Section 25.4: USART implementation on page
573.
RM0091
573.
573.
573.
573.