Renault Laguna III Manual page 1535

Coolant pump inlet pipe: Removal - Refitting
K4M
Special tooling required
Mot. 1202-01 Clip pliers for hose clips
(large size).
Mot. 1202-02 Clip pliers for hose clips
(small size)
Mot. 1448 Remote operation pliers for
hose clips.
Tightening torquesm
coolant pump inlet pipe
bolts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove the front engine cover.
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Drain the cooling system (see 19A, Cooling, Cool-
ing system: Draining - Refilling, page 19A-16) .
a Remove:
- the dipstick (1) ,
- the bolts (2) from the dipstick tube,
COOLING
- the dipstick tube.
25 N.m
a Remove the clip (3) from the heater matrix cooling
hose using the tool (Mot. 1202-01) or (Mot. 1202-
02) or (Mot. 1448).
a Disconnect the heater matrix cooling hose from the
coolant pump inlet pipe.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
128376
a Remove:
- the bolts (4) from the coolant pump inlet pipe,
19A-147
19A
128377
128378