Renault Laguna III Manual page 1983

Hydraulic distributor wiring: Removal - Refitting
V9X, and AJ0
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the internal wiring connector (5) .
a Remove:
- the cable routing retaining bolt (6) ,
- the gearbox wiring guide bolt.
a Disconnect the connectors (7) .
a Unclip the wiring from the gearbox (8) .
AUTOMATIC GEARBOX
134879
134531
a Disconnect the gearbox connector (9) .
a Unclip:
- the gearbox connector,
- the wiring from the gearbox at (10) .
a Remove the hydraulic distributor wiring.
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the hydraulic distributor housing
seal.
a Clean the joint faces using SURFACE CLEANER
(see Vehicle: Parts and consumables for the re-
pair) (04B, Consumables - Products) on the auto-
matic gearbox and on the hydraulic distributor
housing, taking care not to damage the contact sur-
faces.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the hydraulic distributor wiring.
a Clip on:
- the gearbox wiring,
- the gearbox connector.
a Connect the gearbox connector.
a Clip on the gearbox wiring.
a Connect the gearbox connectors.
23A-65
23A
137879