Renault Laguna III Manual page 1193

Heater plugs: Removal - Refitting
K9K, and 780
a
Note:
If the heater plugs stick (11) , use heater plug
removal tool (see Heater plug removal tool:
Use) (Technical Note 5197A, 06A, Tools).
a Unscrew the heater plugs (11) using a 10 mm long
radio socket connected to a universal joint or a
hinged wrench for heater plug.
a Use a hose to unscrew the heater plugs completely
(11) .
a Remove the preheater plugs (11) .
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Without tightening, fit the heater plugs using the
hose.
a Torque tighten the heater plugs (15 Nm).
a Connect the heater plug connectors.
II - FINAL OPERATION.
a Refit:
- the injector rail protector cover,
- the injector rail protector cover nut,
- the injector rail protector cover bolt.
a Clip on the injector rail protector cover.
PREHEATING
a Fit:
a Clip the intercooler air inlet pipe to the turbocharger.
a Refit:
a Clip the electrical wiring to the injector rail protector
a Connect:
a Tighten the intercooler air outlet pipe clip.
a Refit the engine cover.
123295
13C-5
- the intercooler air inlet pipe,
- the intercooler inlet air pipe clip in its original posi-
tion.
- the nut to the intercooler inlet air pipe,
- the intercooler air inlet hose bolt.
cover.
- the camshaft position sensor connector,
- the damper valve connector,
- the intercooler outlet air pipe to the damper valve.
13C