Renault Laguna III Manual page 2013

Oil pressure switch: Removal - Refitting
M9R, and AJ0
a Move aside the cooling hose assembly (12) .
a Remove:
- the hydraulic distributor housing bolts,
- the hydraulic distributor housing,
- the hydraulic distributor housing seal.
AUTOMATIC GEARBOX
118391
117250
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the oil pressure switch connector (13) .
a Remove the oil pressure switch concerned.
REFITTING
I - REFITTING PREPARATION OPERATION
a Clean the joint faces using SURFACE CLEANER
(see Vehicle: Parts and consumables for the re-
pair) (04B, Consumables - Products) on the auto-
matic gearbox and on the hydraulic distributor
housing, taking care not to damage the contact sur-
faces.
a Always replace:
- the hydraulic distributor housing seal,
- the intercooler air inlet pipe seals.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the oil pressure switch concerned.
a Torque tighten the oil pressure switch (4.4 N.m).
a Connect the oil pressure switch connector.
III - FINAL OPERATION
a Refit:
- a new hydraulic distributor housing seal,
- the hydraulic distributor housing,
23A-95
23A
118831