Renault Laguna III Manual page 1429

Cooling radiator: Removal - Refitting
M9R
Special tooling required
Mot. 1448 Remote operation pliers for
hose clips.
Equipment required
refrigerant charging station
tweezers
Tightening torquesm
air conditioning hose
nuts on the condenser
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the engine undertray bolts,
- the engine undertray.
a Drain:
- the refrigerant fluid circuit using the refrigerant
charging station (see Refrigerant circuit: Drain-
ing - Filling) (62A, Air conditioning).
- the coolant circuit (see 19A, Cooling, Cooling
system: Draining - Refilling, page 19A-16) .
a Remove:
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the headlights (see Headlight: Removal - Refit-
ting) (80B, Headlights),
- the front end panel (see Front end panel: Remov-
al - Refitting) (42A, Upper front structure).
COOLING
8 N.m
a Pull the clip (1) of the intercooler air outlet pipe on
the intercooler side using a flat-blade screwdriver.
a Disconnect the intercooler air outlet pipe from the in-
tercooler.
19A-41
19A
123699