Renault Laguna III Manual page 1214

Exhaust gas recirculation solenoid valve: Removal - Refitting
M9R, and 742 or 744 or 746 or 748
a Remove the intercooler air inlet pipe seals using a
tweezers.
a
Note:
Check that the intercooler air inlet pipe seals are
fitted the right way round.
a Refit the intercooler air inlet pipe seals.
ANTIPOLLUTION
115068
115069
14A-13
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the new EGR solenoid valve seals,
- the EGR solenoid valve,
- the EGR solenoid valve bolts.
a Tighten the EGR solenoid valve bolts.
a Connect the EGR solenoid valve connector.
III - FINAL OPERATION
a Refit:
- the new exhaust gas recirculation pipe seals,
- the exhaust gas recirculation pipe,
- the exhaust gas recirculation pipe bolts.
a Tighten the exhaust gas recirculation pipe bolts.
a Refit:
- the damper valve (see 12A, Fuel mixture, Damp-
er valve: Removal - Refitting, page 12A-39) ,
- the intercooler inlet air pipe.
a Clip:
- the intercooler air inlet pipe on the turbocharger,
- the intercooler air inlet pipe on the intercooler.
Note:
Check that the intercooler air inlet pipe is cor-
rectly clipped.
a Refit the intercooler air inlet pipe bolts on the intake
distributor.
a Tighten the intercooler air inlet pipe bolts on the in-
take distributor.
a Fit the cooling radiator top hose to the intercooler air
inlet pipe.
a Refit the cooling radiator top hose nut on the inter-
cooler air inlet pipe.
a Tighten the cooling radiator top hose nut on the in-
tercooler air inlet pipe.
a Refit the engine cover.
a Apply the after repair procedure using the Diagnos-
tic tool :
- connect the Diagnostic tool,
- select the « injection computer » ,
- go to repair mode,
14A