Renault Laguna III Manual page 1507

Water chamber: Removal - Refitting
V9X
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove:
- the water chamber bolts (9) ,
- the water chamber,
- the water chamber seal.
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: Cylinder head cool-
ant outlet unit seal (10,06,01,19).
a Always replace the seal for the turbocharger air out-
let pipe.
a Use SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consuma-
bles - Products) to clean and degrease:
- the water chamber joint face,
- the cylinder head joint face.
WARNING
T o ensure proper sealing, the gasket surfaces
must be clean, dry and not greasy (avoid any fin-
ger marks).
COOLING
a Remove the intercooler air inlet pipe seal on the tur-
bocharger side using a .
134023
a
a Fit a new seal to the intercooler air inlet pipe on the
turbocharger side.
19A-119
Note:
Check that the seal of the intercooler air inlet
pipe on the turbocharger side is fitted the correct
way round.
19A
115068
115069