Renault Laguna III Manual page 1468

Coolant pump: Removal - Refitting
K4M
REFITTING
I - REFITTING PREPARATION OPERATION
a
IMPORTANT
Wear goggles with side protectors for this opera-
tion.
IMPORTANT
Wear leaktight gloves (nitrile type) for this opera-
tion.
WARNING
Do not scrape the joint faces of the aluminium,
any damage caused to the joint face will result in
a risk of leaks.
WARNING
The joint faces must be clean, dry and free from
grease (avoid finger marks).
a Use SUPER CLEANING AGENT FOR JOINT FA-
CES (see Vehicle: Parts and consumables for
the repair) (04B, Consumables - Products) to clean:
- the coolant pump joint face, in case of reuse,
- the cylinder block gasket face.
a Use SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consuma-
bles - Products) to degrease:
- the coolant pump joint face, in case of reuse,
- the cylinder block gasket face.
COOLING
a
a Apply a bead (2) of RESIN ADHESIVE (see Vehi-
cle: Parts and consumables for the repair) (04B,
Consumables - Products) with a width of 0.6 to 1
mm.
19A-80
WARNING
Applying excess sealant could cause it to be
squeezed out when parts are tightened. A mix-
ture of sealant and fluid could damage certain
components (engine, radiator, etc.).
19A
10063