Renault Laguna III Manual page 1802

Right-hand suspended engine mounting: Removal - Refitting
M4R
Special tooling required
Mot. 1852 Conversion support studs for
Mot. 1720 tool
Mot. 1720 Engine stand.
Mot. 1672 Lower engine support.
Tightening torquesm
bolts of the suspended
engine mounting rubber
pad
bolts of the suspended
engine mounting cover
tie-rod rear bolts
IMPORTANT
During this operation, be sure to:
- refrain from smoking or bringing red hot objects
close to the working area,
- be careful of fuel splashes when disconnecting the
union.
WARNING
To avoid any corrosion or damage, protect the
areas on which fuel is likely to run.
WARNING
To prevent impurities from entering the circuit, place
protective plugs on all fuel circuit components
exposed to the open air.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine cover,
- the engine undertray bolts,
- the engine undertray.
ENGINE MOUNTING
62 N.m
62 N.m
105 N.m
19D-56
a Remove:
- the rear suspended engine mounting bolts (1) ,
- the rear suspended engine mounting.
a Remove the tie-rod rear bolts (2) .
19D
123347
128251