Renault Laguna III Manual page 1680

Particle filter temperature sensors: Removal - Refitting
M9R
II - REFITTING OPERATION FOR PART
CONCERNED
a Coat the particle filter downstream temperature sen-
sor screw union with COPPER-ALUMINIUM LU-
BRICANT (see Vehicle: Parts and consumables
for the repair) (MR 415, 04B, Consumables - Prod-
ucts).
a Refit the particle filter downstream temperature sen-
sor.
a
Note:
Use an open-jawed spanner to hold the adapter
union in place and prevent it from loosening. Any
adapter union that is loosened must be replaced.
a Torque tighten the particle filter downstream tem-
perature sensor (30 N.m).
a Clip the particle filter downstream temperature sen-
sor wiring onto the exhaust heat shield, respecting
the colour coding on the wiring.
a Connect the particle filter downstream temperature
sensor connector.
III - FINAL OPERATION
a Fit the exhaust heat shield.
a Refit:
- the new exhaust heat shield retaining clip,
- the engine undertray,
- the engine undertray bolts.
a Check that there are no faults using the Diagnostic
tool.
EXHAUST
19B-114
19B