Renault Laguna III Manual page 1247

Exhaust gas cooler: Removal - Refitting
K9K, and 782
Tightening torquesm
exhaust gas cooler
mounting bolts at the
gearbox end on the
exhaust gas cooler
exhaust gas cooler
mounting bolts at the
timing end on the
exhaust gas cooler
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the exhaust fuel injector cooler (see 19B, Exhaust,
Exhaust fuel injector cooler: Removal - Refit-
ting, page 19B-125) ,
- the engine undertray,
- the exhaust gases duct at the turbocharger outlet
(see Turbocharger outlet exhaust gas duct: Re-
moval - Refitting) ,
- the exhaust gas recirculation rigid pipe (see 14A,
Antipollution, Exhaust gas recirculation rigid
pipe: Removal - Refitting, page 14A-62) ,
- the exhaust gas pressure sensor (see 19B, Ex-
haust, Exhaust gas pressure sensor: Removal -
Refitting, page 19B-93) ,
- the damper valve (see 12A, Fuel mixture, Damp-
er valve: Removal - Refitting, page 12A-39) ,
- the exhaust gas recirculation assembly (see 14A,
Antipollution, Exhaust gas recirculation as-
sembly: Removal - Refitting, page 14A-52) .
ANTIPOLLUTION
12 N.m
12 N.m
14A-46
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the clip (1) from the cooling pipe between
the exhaust gas cooler and the exhaust gas recircu-
lation solenoid valve.
a Disconnect the cooling pipe between the exhaust
gas cooler and the exhaust gas recirculation sole-
noid valve.
a Remove:
- the bolts (2) from the exhaust gas cooler mounting
on the timing end,
- the exhaust gas cooler mounting on the timing end,
14A
138419
138420