Renault Laguna III Manual page 1304

Alternator pulley: Removal - Refitting
V9X
Special tooling required
Mot. 1732 Kit for replacing the alterna-
tor idler pulleys.
Mot. 1832 Set of hexagonal sockets (10
male and female) for refitting
the alternator pulley
Equipment required
pneumatic or electric wrench
Tightening torquesm
alternator pulley
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the engine undertray bolts,
- the engine undertray,
- the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the front right-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (55A, Ex-
terior protection),
- the lower engine tie-bars (see 1 9 D, Engine
mounting, Lower engine tie-bar: Removal - Re-
fitting, page 19D-85) ,
- the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-51) ,
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-13) ,
- the alternator (see 16A, Starting - Charging, Al-
ternator: Removal - Refitting, page 16A-1) .
STARTING - CHARGING
80 N.m
II - OPERATION FOR REMOVAL OF PART
CONCERNED
1 - Removing the alternator pulley using a
pneumatic or electric wrench
a Place the alternator in a vice fitted with jaws.
a Remove the alternator pulley cover (1) .
16A-27
16A
136238