Renault Laguna III Manual page 1127

High pressure pipe between rails: Removal - Refitting
V9X
a Refit the bolts of the high pressure pipe between the
rails.
III - FINAL OPERATION
a Refit the vacuum solenoid valve support.
a Fit the wiring for the heater plugs.
a Connect the heater plug connectors.
a Refit the intercooler air outlet pipe.
a Fit the injector rail protector on the back row.
a Refit the bolts of the injector rail protector on the
back row.
a Connect the exhaust gas recirculation solenoid
valve cooling hose.
a Fit the exhaust gas recirculation solenoid valve hose
clip (Mot. 1448) using the tool.
a Refit:
- the injector rail protector on the front cylinder bank
(see 13B, Diesel injection, Injector rail protec-
tor: Removal - Refitting, page 13B-126) ,
- the injector rail protector cover on the back row.
a Clip the injector rail protector cover on the back row.
a Clip:
- the cooling hose,
- the wiring of the exhaust gas recirculation solenoid
valve.
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
a Fill and bleed the cooling system (see 19A, Cool-
ing, Cooling system: Draining - Refilling, page
19A-16) .
a Refit:
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the engine undertray.
a Prime the diesel circuit using the manual priming
pump.
a Switch on forced + after ignition.
a Connect the Diagnostic tool.
DIESEL INJECTION
13B-188
a In the Diagnostic tool :
- select the repair mode,
- select the programming mode,
- select command SC 035: HIGH PRESSURE FUEL
CIRCUIT FAULT FINDING.
a Check:
- the correct operation of the high pressure fuel cir-
cuit,
- that there are no leaks.
a Refit the engine cover.
13B