Renault Laguna III Manual page 2018

Oil pressure switch: Removal - Refitting
F4R, and AJ0
a Torque tighten the hydraulic distributor housing
bolts (8 Nm).
a Remove the air inlet pipe seal of the intercooler us-
ing a tweezers.
a
Note:
Check that the intercooler air inlet pipe seal is fit-
ted in its groove the right way round.
a Refit a new seal on the intercooler air inlet pipe.
AUTOMATIC GEARBOX
115068
115069
a Rotate the clips of the intercooler air inlet pipe in or-
der to replace them in their groove.
Note:
The intercooler air inlet pipe is correctly clipped
onto the turbocharger and the intercooler when
the clips are engaged in the turbocharger and
intercooler groove.
a Clip the intercooler air inlet pipe onto the intercooler.
a Connect the automatic gearbox oil cooler hoses.
a Fit the clips on the automatic gearbox oil cooler hos-
es using the tool (Mot. 1448).
a Refit:
- the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
- the battery (see Battery: Removal - Refitting)
(80A, Battery),
- the front left-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (55A, Ex-
terior protection),
- the front left-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres).
a Fill up and bleed the cooling system (see Cooling
system: Draining - Refilling) (19A, Cooling).
a Top up the automatic transmission (see 23A, Auto-
matic gearbox, Automatic gearbox oil: Draining -
Filling, page 23A-29) .
a Refit the engine undertray.
a Apply the after repair procedure using the Diagnos-
tic tool :
- connect the Diagnostic tool,
- select « Gearbox computer » ,
- go to repair mode,
- display the « Before/After repair procedure » for
the computer selected,
- select « Hydraulic distributor » in the « List of com-
ponents controlled by this computer » section,
- carry out the operations described in the « After re-
pair procedure » section.
23A-100
23A