Renault Laguna III Manual page 1564

Coolant temperature sensor: Removal - Refitting
V4Y
- the coolant temperature sensor seal.
REFITTING
I - REMOVAL PREPARATION OPERATION
a parts always to be replaced: coolant tempera-
ture sensor seal (10,06,01,18).
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- a new seal on the coolant temperature sensor,
- the temperature sensor on the coolant outlet unit.
a Torque tighten the coolant temperature sensor
(25 N.m).
a Connect the coolant temperature sensor connector.
III - FINAL OPERATION
a Fill and bleed the cooling system (see 19A, Cool-
ing, Cooling system: Draining - Refilling, page
19A-16) .
a Refit:
- the engine undertray,
- the air outlet pipe of the air filter unit.
a Torque tighten the clips for the air filter unit air
outlet pipe and at the inlet of the throttle valve (6
N.m).
a Connect the oil vapour rebreathing pipe.
a Fit the clip onto the oil vapour rebreathing pipe using
the (Mot. 1448).
a Connect the brake servo vacuum pipe.
a Refit the engine cover.
COOLING
19A-176
19A