Renault Laguna III Manual page 1156

Fuel temperature sensor: Removal - Refitting
V9X
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 13B, Diesel injection, Diesel injec-
tion: Precautions for the repair, page 13B-1) .
IMPORTANT
Wear leaktight gloves (Nitrile type) for this opera-
tion.
WARNING
To prevent impurities from entering the circuit, place
protective plugs on all fuel circuit components
exposed to the open air.
WARNING
To avoid any corrosion or damage, protect the
areas on which fuel is likely to run.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove the front engine cover.
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
DIESEL INJECTION
13B-217
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the fuel temperature sensor connector
(1) .
a Unclip the fuel temperature sensor from the fuel re-
turn pipe using a screwdriver.
a Remove the fuel temperature sensor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit the fuel temperature sensor.
a Clip the fuel temperature sensor onto the fuel return
pipe.
a Connect the fuel temperature sensor connector.
II - FINAL OPERATION
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
a Refit the engine cover.
13B
137874