Renault Laguna III Manual page 1672

Particle filter pressure sensor: Removal - Refitting
V9X
Tightening torquesm
particle filter pressure
sensor nut
IMPORTANT
Wear protective gloves during the operation.
IMPORTANT
Wear heat protective gloves during the operation.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine undertray bolts,
- the engine undertray,
- the lower engine tie-bars (see 1 9 D, Engine
mounting, Lower engine tie-bar: Removal - Re-
fitting, page 19D-85) .
EXHAUST
II - OPERATION FOR REMOVAL OF PART
CONCERNED
21 N.m
a Remove the bolt (1) from the particle filter pressure
sensor mounting.
a Move aside the « support - particle filter pressure
sensor » assembly.
a Disconnect the particle filter pressure sensor con-
nector (2) .
19B-106
19B
137907