Renault Laguna III Manual page 2037

Front right-hand driveshaft: Removal - Refitting
AJ0
a Remove the driveshaft relay bearing bolt (4) .
a Push the stub-axle carrier driveshaft by rotating the
latter.
a Remove the front right-hand driveshaft.
DRIVESHAFTS
122648
122651
29A-8
REFITTING
I - REFITTING PREPARATIONS OPERATION
a Clean and grease the driveshaft relay bearing hole
into which the bearing is inserted (see Vehicle:
Parts and consumables for the repair) (MR 415,
04B, Consumables - products).
II - REFITTING OPERATION FOR PART
CONCERNED
a Position and insert the driveshaft into the gearbox.
a Refit:
- the driveshaft into the relay bearing,
- the relay bearing bolt.
a Torque tighten the relay bearing bolt (21 Nm).
a Insert the driveshaft into the stub-axle carrier.
Note:
The driveshaft must fit freely in the stub-axle car-
rier until it protrudes enough for the hub nut to be
fitted.
a Refit:
- the shock absorber base bolts,
- the track rod end nut,
- the hub nut using tool (Rou. 604-01).
a Torque tighten:
- the shock absorber base bolts (180 Nm),
- the track rod end nut (37 Nm),
- the hub nut (105 Nm).
a Clip:
- the brake hose,
- unclip the wheel speed sensor harness.
III - FINAL OPERATION.
a Refit:
- the front right-hand wheel (see Wheel: Removal -
Refitting) (MR 415, 35A, Wheels and tyres),
- the engine undertray.
29A