Renault Laguna III Manual page 1475

Coolant pump: Removal - Refitting
V9X
Tightening torquesm
coolant pump bolts
IMPORTANT
Wear goggles with side protectors for this opera-
tion.
IMPORTANT
Wear protective gloves during the operation.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the engine undertray bolts,
- the engine undertray,
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection).
a Drain the cooling system (see 19A, Cooling, Cool-
ing system: Draining - Refilling, page 19A-16) .
a Remove:
- the lower engine tie-bars (see 1 9 D, Engine
mounting, Lower engine tie-bar: Removal - Re-
fitting, page 19D-85) ,
- the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-51) ,
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-13) .
COOLING
II - OPERATION FOR REMOVAL OF PART
CONCERNED
25 N.m
a Remove:
- the coolant pump pulley bolts (1) ,
- the coolant pump pulley.
a Remove:
- the coolant pump bolts (2) ,
- the coolant pump,
- the coolant pump seal.
19A-87
19A
134124
134125