Renault Laguna III Manual page 2031

Front left-hand driveshaft: Removal - Refitting
AJ0
a Push the stub-axle carrier driveshaft by rotating the
latter.
a
Note:
Do not apply pressure to the gearbox oil/water
temperature exchanger pipes.
a Remove the driveshaft from the gearbox using a le-
ver.
a Remove the front left-hand driveshaft.
DRIVESHAFTS
122653
123652
29A-2
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Fit the driveshaft into the gearbox as horizontally as
possible.
Note:
The driveshaft must fit freely in the stub axle car-
rier until it protrudes enough for the hub nut to be
fitted.
a Engage the driveshaft into the stub axle carrier.
a Refit:
- the shock absorber base bolts,
- the track rod end nut,
- the hub nut using tool (Rou. 604-01).
a Tighten to torque:
- the shock absorber base bolts (180 Nm),
- the track rod end nut (37 Nm),
- the hub nut (105 Nm).
a Clip:
- the brake hose,
- the wheel speed sensor wiring harness.
II - FINAL OPERATION.
a Refit:
- the front left-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the engine undertray.
29A