Renault Laguna III Manual page 1474

Coolant pump: Removal - Refitting
V4Y
a Remove the engine from the component support
(see Engine support equipment: Use) .
a Couple the gearbox to the engine (see Automatic
gearbox: Removal - Refitting) (23A, Automatic
transmission).
a Remove the lifting eye on the timing end (see 11A,
Top and front of engine, Lifting eyes: Removal -
Refitting, page 11A-318) .
a Refit:
- the « engine and gearbox » assembly (see 10A,
Engine and cylinder block assembly, Engine -
gearbox assembly: Removal - Refitting, page
10A-1) ,
- the left-hand suspended engine mounting rubber
pad central nut,
- the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-51) .
a Torque tighten the central nut of the left-hand sus-
pended engine mounting rubber pad (62 N.m).
a Remove the (Mot. 1390) from the « engine -
gearbox » assembly.
a Refit:
- the front and rear catalytic pre-converters (see
Front catalytic pre-converter: Removal - Refit-
ting) and (see Rear catalytic pre-converter: Re-
moval - Refitting) ,
- the front row upstream oxygen sensor (see 17B,
Petrol injection, Oxygen sensors: Removal -
Refitting, page 17B-17) ,
- the inlet manifold (see 12A, Fuel mixture, Inlet
distributor: Removal - Refitting, page 12A-75) ,
- the radiator cross member mounting (see Radiator
cross member mounting: Removal - Refitting)
(41A, Front lower structure),
- the protection and switching unit (see Protection
and Switching Unit: Removal - Refitting) (87G,
Engine compartment connection unit),
- the battery disconnection unit (see Battery dis-
connection unit: Removal - Refitting) (80A, Bat-
tery),
- the front left-hand driveshaft (see Front left-hand
driveshaft: Removal - Refitting) (29A, Drive-
shafts),
- the front right-hand driveshaft (see Front right-
hand driveshaft: Removal - Refitting) (29A,
Driveshafts),
COOLING
- The « cooling radiator - condenser - motor-driven
a Refill:
- the cooling circuit (see 19A, Cooling, Cooling
- the refrigerant circuit using a refrigerant charging
a Refit:
- the air filter unit (see 12A, Fuel mixture, Air filter
- the petrol injection computer (see 17B, Petrol in-
- the front end panel (see Front end panel: Remov-
- the audible warning (see Audible warning: Re-
- the bonnet catch (see Bonnet lock: Removal -
- the headlights (see Headlight: Removal - Refit-
- the front bumper (see Front bumper: Removal -
- the front wheel arch liners (see Front wheel arch
- the front wheels (see Wheel: Removal - Refitting)
- the engine undertray,
- the engine cover.
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
a Check that the air conditioning is working correctly
(see Refrigerant circuit: Check) (62A, Air condi-
tioning).
a Adjust the headlight beams (see Headlight: Adjust-
ment) (80B, Headlights).
19A-86
fan » assembly (see 19A, Cooling, Cooling radia-
tor: Removal - Refitting, page 19A-28) .
system: Draining - Refilling, page 19A-16) ,
station (see Refrigerant circuit: Draining - Fill-
ing) (62A, Air conditioning).
unit: Removal - Refitting, page 12A-13) ,
jection, Petrol injection computer: Removal -
Refitting, page 17B-30) ,
al - Refitting) (42A, Upper front structure),
moval - Refitting) (82B, Horn),
Refitting) (52A, Non-side opening element mecha-
nisms),
ting) (80B, Headlights),
Refitting) (55A, Exterior protection),
liner: Removal - Refitting) (55A, Exterior protec-
tion),
(35A, Wheels and tyres),
19A