Renault Laguna III Manual page 1283

Alternator: Removal - Refitting
K9K
Tightening torquesm
positive terminal nut on
the alternator
IMPORTANT
Wear protective gloves during the operation.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the engine cover,
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the headlights (see Headlight: Removal - Refit-
ting) (80B, Headlights),
- the front end panel (see Front end panel: Remov-
al - Refitting) (42A, Upper front structure),
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-13) .
STARTING - CHARGING
8 N.m
K9K, and 780
a Remove:
- the intercooler air inlet pipe bolt (1) ,
- the nut (2) of the intercooler air inlet pipe.
a Pull the clip (3) of the intercooler air inlet pipe.
a Disconnect the intercooler air inlet pipe.
16A-6
16A
123293
123299