Renault Laguna III Manual page 2027

Converter seal: Removal - Refitting
AJ0
- the engine - gearbox assembly (see Engine -
gearbox assembly: Removal - Refitting) (MR
415, 10A, Engine and peripherals),
- the left-hand suspended engine mounting (see
Left-hand suspended engine mounting: Re-
moval - Refitting) (MR 415, 19D, Engine mount-
ing),
- the right-hand suspended engine mounting (see
Right-hand suspended engine mounting: Re-
moval - Refitting) (MR 415, 19D, Engine mount-
ing),
- the rear suspended engine mounting (see Lower
engine tie-bar: Removal - Refitting) (MR 415,
19D, Engine mounting),
- the radiator mounting cross member (see Radiator
mounting cross member: Removal - Refitting)
(MR 416, 41A, Front lower structure),
- the particle filter (see Particle filter: Removal -
Refitting) (MR 415, 19B, Exhaust),
- the front end panel (see Front end panel: Remov-
al - Refitting) (MR 416, 42A, Front upper struc-
ture),
- the headlights (see Headlight: Removal - Refit-
ting) (MR 415, 80B, Headlights),
- the front bumper (see Front bumper: Removal -
Refitting) (MR 416, 55A, Exterior protection),
- the front left-hand driveshaft (see 29A, Drive-
shafts, Front left-hand driveshaft: Removal -
Refitting, page 29A-1) ,
- the front right-hand driveshaft (see 29A, Drive-
shafts, Front right-hand driveshaft: Removal -
Refitting, page 29A-7) ,
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (MR 416, 55A, Exterior
protection),
- the front wheels (see Wheel: Removal - Refitting)
(MR 415, 35A, Wheels and tyres),
- the air filter box (see Air filter unit: Removal - Re-
fitting) (MR 415, 12A, Fuel mixture),
- the injection computer (see Diesel injection com-
puter: Removal - Refitting) (MR 415, 13B, Diesel
injection) or (see Petrol injection computer: Re-
moval - Refitting) (MR 415, 17B, Petrol injection),
- the battery tray (see Battery tray: Removal - Re-
fitting) (MR 415, 80A, Battery),
- the battery (see Battery: Removal - Refitting)
(MR 415, 80A, Battery).
a Fill and bleed the cooling system (see Cooling sys-
tem: Draining - Refilling) (MR 415, 19A, Cooling).
AUTOMATIC GEARBOX
a Refill:
- the refrigerant circuit (see Refrigerant circuit:
Draining - Filling) (MR 415, 62A, Air conditioning),
- the automatic gearbox (see 23A, Automatic gear-
box, Automatic gearbox oil: Draining - Filling,
page 23A-29) .
a Apply the after repair procedure using the Diagnos-
tic tool :
a Connect the Diagnostic tool
Select gearbox computer
Go to repair mode
Display the gearbox computer « Before/after
repair » procedure
Carry out the operations described in the « After re-
pair procedure » section.
a Refit:
- the engine undertray,
- the engine undertray bolts,
- the engine cover.
23A-109
23A