Renault Laguna III Manual page 1532

Coolant pump inlet pipe: Removal - Refitting
M9R, and 800 or 802 or 805 or 806 or 808 or 809 or 816 or 845 or 849
Special tooling required
Mot. 1448 Remote operation pliers for
hose clips.
Tightening torquesm
coolant pump inlet pipe
bolt on the cylinder
block
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the battery (see Battery: Removal - Refitting)
(80A, Battery),
- the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
- the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-13) ,
- the damper valve (see 12A, Fuel mixture, Damp-
er valve: Removal - Refitting, page 12A-39) ,
- the EGR solenoid valve (see 14A, Antipollution,
Exhaust gas recirculation solenoid valve: Re-
moval - Refitting, page 14A-11) ,
- the engine undertray bolts,
- the engine undertray.
a Drain the cooling system (see 19A, Cooling, Cool-
ing system: Draining - Refilling, page 19A-16) .
a Remove:
- the water chamber (see 1 9 A, Cooling, Water
chamber: Removal - Refitting, page 19A-100) ,
- the exhaust gas recirculation rigid pipe (see 14A,
Antipollution, Exhaust gas recirculation rigid
pipe: Removal - Refitting, page 14A-62) ,
- the starter (see 16A, Starting - Charging, Starter:
Removal - Refitting, page 16A-31) ,
- the exhaust cooler (see 14A, Antipollution, Ex-
haust gas cooler: Removal - Refitting, page
14A-33) .
COOLING
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Unclip the alternator wiring.
10 N.m
a Remove the coolant outlet union bolts (1) on the oil
filter unit.
19A-144
19A
123957