Renault Laguna III Manual page 1743

Filler neck: Removal - Refitting
F4R or K4M or M4R or V4Y
Tightening torquesm
fuel tank bolts
electronic parking brake
control unit mounting
bolts
filler neck earth bolt
IMPORTANT
During this operation, be sure to:
- refrain from smoking or bringing red hot objects
close to the working area,
- be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear latex gloves during the operation.
IMPORTANT
Wear goggles with side protectors for this opera-
tion.
WARNING
To avoid any corrosion or damage, protect the
areas on which fuel is likely to run.
WARNING
Keep the pipe unions away from contaminated
areas.
WARNING
To prevent impurities from entering the circuit, place
protective plugs on all fuel circuit components
exposed to the open air.
TANK
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
21 N.m
Towing and lifting) (02A, Lifting equipment).
21 N.m
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Drain the fuel tank (see 19C, Tank, Fuel tank:
21 N.m
Draining, page 19C-7) .
a Open the fuel tank flap.
a Remove:
- the filler neck bolts (1) ,
- the rear right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the rear right-hand wheel arch liner (see Rear
wheel arch liner: Removal - Refitting) (55A, Ex-
terior protection).
19C-34
19C
124242