Renault Laguna III Manual page 1536

Coolant pump inlet pipe: Removal - Refitting
K4M
- the coolant pump inlet pipe.
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the coolant pump inlet pipe seal.
a Use SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consuma-
bles - Products) to clean and degrease:
- the seal housing in the cylinder block,
- the coolant pump inlet pipe seal housing if it is be-
ing reused.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the coolant pump inlet pipe fitted with a new
seal.
a Torque tighten in order the coolant pump inlet pipe
bolts (25 N.m).
III - FINAL OPERATION.
a Connect the heater matrix cooling hose onto the
coolant pump inlet pipe.
a Fit the heater matrix cooling hose clip using the tool
(Mot. 1202-01) or (Mot. 1202-02) or (Mot. 1448).
a Refit:
- dipstick guide ,
- the dipstick.
COOLING
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
a Refit the engine cover.
a Perform the following operations:
- fill the cooling system (see 19A, Cooling, Cooling
- bleed the cooling system (see 19A, Cooling, Cool-
128378
19A-148
system: Draining - Refilling, page 19A-16) ,
ing system: Draining - Refilling, page 19A-16) .
19A