Renault Laguna III Manual page 1977

Hydraulic distributor wiring: Removal - Refitting
V4Y, and AJ0
Special tooling required
Mot. 1448 Remote operation pliers for
hose clips.
Equipment required
Diagnostic tool
Tightening torquesm
wire routing retaining
bolt
hydra u l i c d i s t ributor
housing bolts
clips for the air filter unit
air outlet pipe and the
clip at the inlet of the
throttle valve
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove the front engine cover.
AUTOMATIC GEARBOX
7 N.m
8 Nm
5.5 N.m
a Disconnect the vacuum pipe from the brake servo
(1) .
a Move the brake servo vacuum pipe to one side.
a Undo:
- the clip (2) for the throttle valve air inlet pipe,
- the clip for the air filter unit air outlet pipe.
a Remove the clip from the oil vapour rebreathing pipe
using the tool (Mot. 1448).
a Disconnect the oil vapour rebreathing pipe.
a Remove:
- the air outlet pipe to the air filter unit,
- the air filter unit (see Air filter unit: Removal - Re-
fitting) (12A, Fuel mixture),
- the protection and switching unit (see Protection
and Switching Unit: Removal - Refitting) (87G,
Engine compartment connection unit),
- the engine undertray bolts,
- the engine undertray,
- the max fuse box cover.
a Unclip the max fuse box from its support.
23A-59
23A
133471