Renault Laguna III Manual page 1376

Crankshaft position sensor: Removal - Refitting
V4Y
Tightening torquesm
crankshaft position sen-
sor bolt
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine undertray bolts,
- the engine undertray.
a Remove the protective sheath (1) from the crank-
shaft position sensor wiring.
PETROL INJECTION
7 N.m
134510
17B-38
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the crankshaft position sensor connector
(2) .
a Remove:
- the crankshaft position sensor bolt (3) ,
- the crankshaft position sensor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit the crankshaft position sensor.
a Torque tighten the crankshaft position sensor
bolt (7 N.m).
a Connect the crankshaft position sensor connector.
II - FINAL OPERATION
a Fit the protective sheath on the crankshaft position
sensor wiring.
a Refit the engine undertray.
17B
134510