Renault Laguna III Manual page 1879

Manual gearbox: Removal - Refitting
M9R, and PK4
- the upper nuts on the gearbox.
a Torque tighten the upper nuts on the gearbox (44
N.m).
a Clip the heater matrix pipes on the heater matrix re-
taining bracket.
a Refit:
- the gearbox support,
- the gearbox support bolts.
a Torque tighten the gearbox support bolts (105
N.m).
III - FINAL OPERATION.
a Fit the wiring on the gearbox support.
a Refit the wiring bolt on the gearbox support.
a Tighten the wiring bolt on the gearbox support.
a Refit:
- the left-hand suspended engine mounting rubber
pad,
- the bolts on left-hand suspended engine mounting
rubber pad.
a Tighten the left-hand suspended engine mounting
rubber pad nuts.
a Refit the left-hand suspended engine mounting shaft
nut.
a Tighten the left-hand suspended engine mounting
shaft nut.
a Remove the (Mot. 1453) and (Mot. 1453-01).
a Refit:
- the front axle subframe (see Front axle subframe:
Removal - Refitting) (31A, Front axle compo-
nents),
- the engine tie-bar (see Lower engine tie-bar: Re-
moval - Refitting) (19D, Engine mounting),
- the radiator mounting cross member (see Radiator
mounting cross member: Removal - Refitting)
(41A, Front lower structure),
- the front left-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (55A, Ex-
terior protection),
- differential output seals (see 21A, Manual gear-
box, Differential output seal: Removal - Refit-
ting, page 21A-6) ,
- the front left-hand driveshaft (see 29A, Drive-
shafts, Front left-hand driveshaft: Removal -
Refitting, page 29A-1) ,
MANUAL GEARBOX
21A-20
- the front right-hand driveshaft (see 29A, Drive-
shafts, Front right-hand driveshaft: Removal -
Refitting, page 29A-7) ,
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the starter (see Starter: Removal - Refitting)
(16A, Starting - Charging),
a Top up the gearbox (see 21A, Manual gearbox,
Manual gearbox oils: Draining - Filling, page
21A-2) .
a Remove the retaining belt from the cooling assem-
bly.
a Refit the cooling assembly protector.
a Clip:
- the gearbox control cables on their support,
- the gear control cables onto the gear selector ball
joints,
- the clutch pipe,
- the oil vapour pipe.
a Adjust the gear control cables (see Gear control
unit: Adjustment) .
a Connect the rigid clutch pipe to the clutch thrust
bearing.
a Remove the tool (Ms. 583) from the brake fluid res-
ervoir outlet pipe.
a Bleed the clutch control circuit (see Clutch circuit:
Bleed) (37A, Mechanical component controls).
a Refit:
- the engine undertray,
- the engine undertray bolts.
a Clip the wiring on the reverse gear sensor.
a Connect the reverse gear sensor connector.
a Refit:
- the air filter box (see Air filter unit: Removal - Re-
fitting) (12A, Fuel mixture),
- the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
- the battery (see Battery: Removal - Refitting)
(80A, Battery).
21A