Renault Laguna III Manual page 1979

Hydraulic distributor wiring: Removal - Refitting
V4Y, and AJ0
a Remove:
- the wire routing retaining bolt (6) ,
- the gearbox wiring guide bolt.
a Disconnect the connectors (7) .
a Unclip the wiring from the gearbox (8) .
a Disconnect the gearbox connector (9) .
a Remove the bolt (10) from the gearbox connector
support.
a Unclip the bonnet release cable from the gearbox
connector support.
AUTOMATIC GEARBOX
134531
134195
a Remove the hydraulic distributor wiring.
REFITTING
I - REFITTING PREPARATION OPERATION
a Clean the joint faces using SURFACE CLEANER
(see Vehicle: Parts and consumables for the re-
pair) (04B, Consumables - Products) on the auto-
matic gearbox and on the hydraulic distributor
housing, taking care not to damage the contact sur-
faces.
a Always replace the hydraulic distributor housing
seal.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the hydraulic distributor wiring.
a Clip the bonnet release cable onto the gearbox con-
nector support.
a Refit the gearbox connector support.
a Connect the gearbox connector.
a Clip on the gearbox wiring.
a Connect:
- the automatic gearbox connectors,
- the internal wiring connector.
a Refit:
- the gearbox wiring guide,
- the wire routing retaining bolt.
a Torque tighten the wire routing retaining bolt (7
N.m).
III - FINAL OPERATION
a Refit:
- a new hydraulic distributor housing seal,
- the hydraulic distributor housing.
a Torque tighten the hydraulic distributor housing
bolts (8 Nm).
a Fit the gearbox control cable.
a Refit the max fuse box support.
a Clip the max fuse box onto its support.
a Refit:
- the max fuse box cover,
- the engine undertray,
23A-61
23A