Renault Laguna III Manual page 1257

Exhaust gas recirculation assembly: Removal - Refitting
K9K, and 782
Special tooling required
Ms. 583 Pipe clamps.
Mot. 1448 Remote operation pliers for
hose clips.
Tightening torquesm
exhaust gas recircula-
tion assembly bolts
timing end lifting eye
bolts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the exhaust fuel injector cooler (see 19B, Exhaust,
Exhaust fuel injector cooler: Removal - Refit-
ting, page 19B-125) ,
- the engine undertray,
- the exhaust gases duct at the turbocharger outlet
(see Turbocharger outlet exhaust gas duct: Re-
moval - Refitting) ,
- the exhaust gas recirculation rigid pipe (see 14A,
Antipollution, Exhaust gas recirculation rigid
pipe: Removal - Refitting, page 14A-62) ,
- the exhaust gas pressure sensor (see 19B, Ex-
haust, Exhaust gas pressure sensor: Removal -
Refitting, page 19B-93) .
ANTIPOLLUTION
25 N.m
25 N.m
14A-56
a Remove:
- the nut (1) for the intermediate air pipe between the
turbocharger and the intercooler,
- the bolt (2) of the intermediate air pipe between the
turbocharger and the intercooler,
- the clip (3) of the intermediate air pipe between the
turbocharger and the intercooler.
a Disconnect the intermediate air pipe between the
turbocharger and the intercooler.
a Remove the intermediate air pipe between the tur-
bocharger and the intercooler.
14A
138389
138390