Renault Laguna III Manual page 1789

Left-hand suspended engine mounting: Removal - Refitting
V9X
Special tooling required
Mot. 1852 Conversion support studs for
Mot. 1720 tool
Mot. 1720 Engine stand.
Mot. 1672 Lower engine support.
Tightening torquesm
bolts of the suspended
engine mounting sup-
port shaft on the gear-
box
rubber pad upper bolts
of the suspended
engine mounting on the
gearbox
central nut of the sus-
pended engine mount-
ing shaft on the gearbox
tie rod rear bolts
upper engine tie-bar
bolts
bolt of the upper engine
tie-bar bracket
earth nuts on the front
left-hand side member
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the engine cover,
- the engine undertray bolts,
- the engine undertray,
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
ENGINE MOUNTING
105 N.m
105 N.m
62 N.m
105 N.m
115 N.m
62 N.m
8 N.m
19D-43
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the left-hand headlight (see Headlight: Removal -
Refitting) (80B, Headlights),
- the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-13) .
a Remove the bolt (1) from the max fuse box.
a Remove the clip (2) from the max fuse box.
a Move the max fuse box to one side.
19D
137883
137882